Installing the Transceiver Tap
ST-500 INSTALLATION GUIDE
Page 2-9
require cutting the network cable and installing male-mating connectors
to attach the transceiver. A barrel (female to female) connector is used
to provide network cable continuity when the transceiver is not installed.
.
Figure 2-8. N-Series and BNC Taps
If the tap is already installed on the transceiver body, go to step 3. Oth-
erwise, proceed as follows:
1.
Remove the two flat-head screws from the transceiver case and
insert the tap into the rectangular opening in the case (see
Figure 2-9). Make sure the tap pins are aligned with the connector
block on the transceiver circuit board.
Caution:
Avoid forcing the tap into the case. Very little pressure is
needed. If the tap does not seat easily, remove the tap and examine the
tap and connector block for obstructions.
ST-500-2 TRANSCEIVER WITH N-SERIES
(INTRUSIVE) ETHERNET TAP
ST-500-3 TRANSCEIVER WITH
BNC THIN-NET TAP
BNC FEMALE-TO-FEMALE
BARREL CONNECTOR
N-SERIES FEMALE-TO-FEMALE
BARREL CONNECTOR
SQE
PWR
XMT
RCV
CLN
PWR
SQE
XMT
RCV
CLN
