CHAPTER 2:
INSTALLATION
Page 2-10
ST-500 INSTALLATION GUIDE
Figure 2-9. Installing the Tap
2.
Insert and tighten the flat-head screws (see Figure 2-9).
3.
Test the transceiver and transceiver tap using a Cabletron
Systems LAN-MD Transceiver and Cable Tester.
4.
Select a location for the transceiver and note the following:
a.
If a barrel connector is not installed at the location where the
transceiver will be attached, the cable must be cut and BNC
or N-series connectors, as applicable, must be installed by a
qualified technician.
b.
If a barrel connector is installed at the location for the
transceiver, remove the barrel connector and install the
transceiver in its place.
Note:
If the transceiver is the last device on the network cable, connect
a terminator to the open end of the T-connector.
5.
The transceiver is now ready to connect to the host system cable.
Proceed to Section 2.6.
PWR
SQE
XMT
RCV
CLN
TAP
ASSEMBLY
CONNECTOR
BLOCK
TRANSCEIVER
CASE
FLAT-HEAD
SCREWS
