Cabletron Systems SmartCell 6A000, Руководство пользователя

Страница: 78 / 114

5-4 SmartCell 6A000 User Guide
Troubleshooting Congestion Troubleshooting
5.4.1 Diagnosing Congestion
1.
Enter the
show portstats
command, and take the default of (
all
).
2.
If cells are not being dropped on all ports, proceed to the “Port Congestion” section.
3.
If cells are being dropped on all ports, the indication is global congestion. Proceed to the “Global
Congestion” section.
5.4.2 Global Congestion
1.
Is the total cell drop rate equal to the Unknown VC cell drop rate?
•
If yes, the switch is improperly set up. Check the switch configuration.
•
If no, this indicates global congestion. Continue.
2.
Set the
porttrafficcongestion
values to those recommended in the “QoS Queue Allocation
Guidelines” section. Has the congestion subsided?
•
If yes, you are done.
•
If no, continue.
3.
Have you changed the EPD threshold?
•
If yes, replace it to the default setting. If congestion subsides, you are done.
•
If no, continue.
4.
Enter the
show cacinfo
command for each port. Is the allocated bandwidth small and is the traffic
mostly UBR?
•
If no, go back to step 4 and check next port.
•
If yes, continue.
5.
Enter the
show porttrafficcongestion
command. Is the UBR queue Max threshold large?
•
If no, go back to 4.
•
If yes, continue.
6.
Reduce the UBR queue Max threshold by a small amount, then wait a few minutes.
7.
Enter the
show portstats
command, and take the default of
all
. Is the number of cells dropped
increasing for this port, and quickly decreasing for all other ports?
•
If yes, proceed to the “Port Congestion” section.
•
If no, continue.
8.
Is the number of cells being dropped by all other ports decreasing somewhat?
•
If no, go back to step 6.
•
If yes, continue.
9.
Enter the
set caceqbwallocscheme
command and set call admission control for this port to a more
conservative policy (
moderate
or
conservative
).
10.
Go back to step 4 until all ports have been checked.