Chapter 3: Installation
Page 3-12
MicroMMAC Installation Guide
3.8.2 Attaching the Strain-Relief Bracket
To attach the strain-relief bracket to the bottom of the MicroMMAC,
perform the following steps:
1. Locate the strain-relief bracket and four 8-32 x 3/8-inch screws from
the MicroMMAC-ACCY-KIT package.
2. Attach the strain-relief bracket to the bottom of the MicroMMAC as
shown in Figure 3-8.
Figure 3-8
Attaching the Strain-Relief Bracket
Do NOT attempt to attach the strain-relief bracket with screws
other than the 8-32 x 3/8-inch screws included with the
MicroMMAC accessory kit. Use of longer screws may damage
the unit or cause electrical shock.
R
EPIM 2
MicroMMAC-24E
10BASE-T HUB
WITH
LANVIEW
EPIM 1
STRAIN-RELIEF BRACKET
SCREWS (4)
090807
