Using the Reset Button
MicroMMAC Installation Guide
Page 2-7
2.4 USING THE RESET BUTTON
Use the Reset button to initialize (reboot) the MicroMMAC processor.
Pressing the Reset button causes the hub to clear all counters, run self-test
diagnostics, and reload the firmware image into Local Dynamic Random
Access Memory (LDRAM).
Use a pen or pencil to press the Reset button. The MicroMMAC re-boots
and initializes the processor.
Table 2-5
Saved System Messages
Displayed Messages
Comments
BootP Host
xxx.xxx.xxx.xxx
The IP address of the server from which a
BootP image was downloaded to the
MicroMMAC.
TFTP Host
xxx.xxx.xxx.xxx
The IP address of the server from which a
BootP image was downloaded to the
MicroMMAC.
Last TFTP Host
xxx.xxx.xxx.xxx
The IP address of the server from which the
most recent BootP image was downloaded to
the MicroMMAC.
TFTP File
xxxxxxxxxxxxxxxx
The filename of an image downloaded to the
MicroMMAC.
Last TFTP File
xxx.xxx.xxx.xxx
The filename of the most recently downloaded
image to the MicroMMAC.
NOTE
The Reset button does not clear Non-Volatile Random Access
Memory (NVRAM).
