Cabletron Systems CSMIM-T1, Руководство по установке

Страница: 137 / 198

Commands
CSMIM-T1 Hardware Installation Guide 7-11
&D n DTR Control
&D0 Ignores DTR. DTR not needed for auto-answer.
&D1 Enters command state on detecting On-to-Off transition of DTR;
DTR not needed for auto-answer.
&D2 Goes on hook on detecting On-to-Off transition of DTR and
prepares the serial port to accept an AT at any speed. DTR needed
for auto-answer.
&D3 Goes on hook and resets on detecting On-to-Off transition of DTR
and prepares the serial port to accept an AT at any speed. DTR
needed for auto-answer.
The On-to-Off transition of DTR must last as long as the value
specified in register S25 (default is 0.05 second). Positive
transitions of DTR (Off-to-On) that occur within five seconds
after disconnect are ignored.
-D Repeat Dial
-D <dial string> Where <dial string> is a string of up to 98
characters. Valid dial string characters are: 0-9, dial modifiers,
and for tone dial, #, A, B, C, D and *. The modem ignores invalid
characters.
-DL Redials the last number dialed.
Redials a number up to 9 tries until connection. In reliable mode,
it does not redial if a remote modem answers but fails to establish
a reliable connection.
\D n Serial-Port DSR/CTS Control
\D0 DSR and CTS always On.
\D1 DSR and CTS follow DCD. If &C1 is also set, DSR follows off
hook.
\D2 DSR and CTS both follow DCD.
\D3 DSR complies with ITU-T recommendations, CTS always On.
\D4 DSR and CTS comply with ITU-T recommendations.
Controls the Data Set Ready (DSR) and Clear To Send (CTS)
signals on the serial port.
Table 7-1 shows the &C and \D settings and the result of
combining the two commands: