6-4
CRBRIM-W/E
CHAPTER 6: Maintenance
Figure 6-2. Removing and Replacing the DRAM SIMM
4.
Using the system board orientation shown in Figure 6-2 (top), position the
new SIMM so that the polarization notch is located at the right end of the
SIMM socket.
5.
Insert the new DRAM SIMM by sliding the edge with the metal fingers into
the SIMM connector socket at a slight angle to the socket. Gently rock the
SIMM back into place until the latch on either side snaps into place. Do not
use excessive force, or the connector could break.
6.
Connect the CRBRIM-W/E to a console terminal.
CRBRIM-W/E Faceplate
SIMM Socket
DRAM SIMM
Polarization Notch
DRAM SIMM Installed
