GPIM Network Connections
3-12
Installation
3.7.2
Connecting the GPIM
To connect the GPIM using fiber optic cable to the network, perform the following steps:
1.
Remove the protective covers from the fiber optic ports and from the ends of the connectors.
2.
Insert one end of the SC connector, key side toward the key latches, into the GPIM-01 or
GPIM-09 in the 6H262-18. See
Figure 3-9
. Ensure that the appropriate cable is used for the
application of the GPIM. Refer to
Chapter 2
to determine choose the appropriate GPIM for the
fiber optic cable used in the installation.
NOTE
If connecting the GPIM-09 to the network using multimode fiber optic cable, refer to
Section 3.7.1
before following this procedure.
!
CAUTION
The GPIM-01 and GPIM-09 use Class 1 lasers. Do not use optical instruments to view
the laser output. The use of optical instruments to view laser output increases eye
hazard. When viewing the output optical port, power must be removed from the network
adapter.
NOTE
Leave the protective covers in place when the connectors or ports are not in use to
prevent contamination.
Do not touch the ends of the fiber optic strands, and do not let the ends come in contact
with dust, dirt, or other contaminants. Contamination of the ends causes problems in
data transmission. If the ends become contaminated, blow the surfaces clean with a
canned duster. A fiber optic port cleaning swab saturated with optical-grade isopropyl
alcohol may also be used to clean the ends.
