Cablescan 64, Инструкция по эксплуатации

Страница: 36 / 53

Page 28 Model 64/64x2 Instruction Manual
WIRE IDENTIFICATION (SEARCH)
The Model 64 may be used as an assembly or troubleshooting aid, using the SEARCH function
and the wrist strap or probe. To select and use the SEARCH function, proceed as follows:
1. Insert wrist strap or probe lead into PROBE jack on rear panel.
2. Fasten strap around one wrist, or grasp probe.
3. Connect harness or assembly fixture.
4. Press Up or Down arrow to step through the menu until SEARCH is displayed.
5. Press MENU RUN to initiate SEARCH function.
6. Touch wire end with hand or probe, and the display will show the pin number(s) of
that wire.
7. Touch another wire, and its corresponding pin number(s) will be displayed.
NOTE
If more than one wire is touched at a time, or if the wire touched
is connected to others, the display will scroll through the
numbers in succession.
CLEARING WORKING MEMORY (CLEAR MEMORY)
This function is used for clearing User Labels from the working memory before running a
LEARN KNOWN GOOD. If User Labels previously loaded into the working memory along
with another program are not cleared, the labels will be attached to the test points for the new
program generated with the learn mode. CLEAR MEMORY must first be enabled by the
ENABLE jack on the rear panel. To initiate and use CLEAR MEMORY, proceed as follows:
1. Engage ENABLE jack on the rear panel.
2. Press Up or Down arrow to step through the menu until CLEAR MEMORY is
displayed.
3. Press MENU RUN key to initiate CLEAR MEMORY. The display will ask:
CLEAR MEMORY?
4. If you selected CLEAR MEMORY in error, or otherwise decided not to use it,
press RESET to exit. If you do want to clear the working memory, press MENU
RUN key a second time, and the memory will be cleared. The display will now
show:
Memory Cleared