Cablescan 64, Инструкция по эксплуатации

Страница: 35 / 53

Model 64/64x2 Instruction Manual Page 27
RANDOM BUILD (RANDOM BUILD
RANDOM BUILD provides assembly continuities (From/To points) for wire ends selected
(touched) at random (no specific sequence required). A complete procedure is provided below.
To select and use RANDOM BUILD in making wire connections, proceed as follows:
1. Load program to be used (refer to "Loading a Program").
2. Attach wrist strap to arm, and plug wrist strap lead into PROBE receptacle on rear
panel.
3. If available, plug the optional footswitch lead into FOOTSWITCH jack on rear
panel.
4. Connect harness assembly fixture.
5. Press RANDOM BUILD key; the display will show:
Select Next Wire
6. Touch the end of a random wire to assemble, and the display will show the
From/To points.
7. Make the termination; if made correctly, the tone will sound and the display will
show:
Select Next Wire
8. Touch each succeeding wire, in any order desired, and make terminations as in
Steps 6 and 7, above. An "F" will appear at the left of the display when the FROM
point is touched, and a "T" will appear when the TO point is touched. Also, as
soon as either the FROM or TO point is touched, an intermittent tone will sound.
The tone and the "F" or "T" will be present only while the points are being
touched.
9. To cancel a displayed From/To point, press either the RANDOM BUILD key or
the footswitch.
10. After all wires are assembled, press TEST to locate any shorts that may have been
created.
NOTE
Only From/To points that are part of the wire list program and
not terminated are displayed. Test points not in the wire list are
not displayed. Refer to “Wire Identification (Search)” for
displaying points without using a wire list program.