Cablescan 4000C, Инструкция по эксплуатации

Страница: 37 / 83

Model 4000C Instruction Manual Page 27
Directory of Drive 0
This function is used to display and load programs from the internal 3.5-inch disk drive. To
select this function, press either arrow key until
DIRECTORY 0 is displayed, then press
MENU RUN. The Model 4000C will read the directory of the internal 3.5-inch floppy and
display the first file name. To view other files on disk, press the Down arrow to scroll
through subsequent file names. To load a file (program), press the Down arrow until the
desired file name is displayed, then press MENU RUN to load the program (or press RESET
to cancel the function). While the file is loading, the display will show "
loading program ."
After the program has been successfully loaded, the display will show OK .
Directory of Drive 1
This function is used to display and load programs from the external disk drive connected to
the rear panel on some Model 4000C testers. The operation of this function is identical to the
Directory 0.
Print Wire List
This function prints the program currently in memory. If a CRT/Keyboard Terminal is
connected the wire listing will also be displayed on the CRT. The listing output can be
temporarily halted by holding the CTRL key down and pressing “s” on the keyboard. To
continue the listing, hold CRTL and press “q”. To select and run Print Wire List, proceed as
follows:
1. Verify that a serial printer is connected according to the Printer Hookup procedure in the
Preparation section.
2. Press Up or Down arrow to step through the menu to display PRINT WIRE LIST .
3. Press MENU RUN to initiate printing. A sample wire list is shown below.
11-26-96
Wire List
USER PROGRAMMABLE CUSTOM HEADER
Sequence From Pt. To Pt. Circuit ID
001 5 13
002 4 14
003 3 12
004 2 11
005 1 10
006 9 15
007 8 16
End of List
Without
User Labels