CAB THARO Apollo 1 Series, Руководство оператора

Страница: 97 / 139

97 cab - Produkttechnik GmbH & Co KG / Tharo Systems, Inc.
1. Lift the printhead by turning the lever (7) clockwise until it stops.
2. Loosen the knurled screw (11) and swing media retainer (10) backwards.
3. Place the media roll (8) onto the media hub (9). Swing the media retainer
(10) to the media hub and inwards until it rests against the side of the roll.
Tighten the knurled screw (11).
4. Slide the two media guides (15/16) to their outermost position.
5. Unroll a length of media stock and feed it through the Apollo as shown in
Figure 13 o. It is particularly important to ensure that the media strip slides
properly between the adjustable fittings of the photocell assembly (17).
6. Feed the media strip between the print roller and the thermal printhead,
and then over the dispense edge (19) up to the internal rewinder (14).
7. Slide the media strip from underneath the rewinder clamps (12) to the
disc. Fasten the media strip to the axle by holding the rewinder (14) and
rotating the knurled knob (13) clockwise until it stops. To tighten the media,
rotate rewinder counter-clockwise.
8. Slide the two media guides (15/16) against the edge of the media strip.
9. Lock the printhead by turning the lever (7) counter-clockwise until it stops.
10. Activate the peel-off function by selecting the peel-off mode in the software
(in direct programming use the "P" command).
NOTICE !
If you do not use the printer for an extended period of time, lift the
printhead to avoid possible flattening of the print roller.
Fig. 13 o Inserting the labels for peel-off
Inserting the Labels for Peel-off
13 14 15 16 17 18
7 8 9 10 11
19
20
6
12