CAB A3, Руководство оператора

Страница: 67 / 144

67 cab Produkttechnik GmbH & Co KG
Tear-off mode
When the "Tear-off mode" is active, an additional feed forward will take place
after completion of the print job. This additional feed makes it possible to cut
or tear off the last label at the tear-off plate. When a new print job is started,
the label material will be fed back until the front edge of the first label is
repositioned under the printhead.
If the parameter is OFF, the label feed forward stops immediately after the last
label has completely passed the printhead.
Backfeed
In cut and peel-off mode, the material will be stopped in a position where the
leading edge of the following label has already been forwarded beyond the
printhead. The printer will then backfeed the label material from its cut/
dispense position to the printhead. Therefore, the next label can be printed
completely.
A backfeed will always be performed if the parameter is set to "always". If the
setting is set to "smart", the backfeed will only be performed if the front label is
in its cut/dispense position and the printer has not yet received all of the data
for printing the following label. Otherwise, the print of the second label will be
started, but only completed once the first label has been removed.
Pause reprint
When this option is enabled (On), it is possible to print additional labels by
pressing the
key after the print job has completed, as long as the
internal memory of the printer has not been cleared by pressing the key.
Error-Reprint
When a recoverable error occurs while printing, this option will determine how
the last label will be handled. If this option is enabled (On), the last label will be
reprinted once the error has been cleared. If this option is disabled (Off), the
print job will continue with the next label.
Width ASCII dump
The ASCII Dump mode (see chapter 9) provides a method to print the control
sequences sent to the interface. In this mode the data received will be printed
in text format depending on the selected character set.
If the parameter "Width ASCII dump" is set to "Automatic" the information is
printed over the maximum print width. For printing the ASCII dump on to
narrow material a smaller width can be chosen.
8. Printer Configuration