CAB A2+, Руководство по настройке пользователя

Страница: 16 / 56

16 16
4 Configuration
4.1.3 Print Parameters
Press the
menu
button.
Select
Setup > Print param.
.
Parameter Meaning Default
Heat level Heating value for compensating for the differing thermal behavior of
printheads. Changing this value is then especially necessary if the
printing intensity has changed after replacing the printhead.
To adapt the printing intensity when using different media, print
speeds or printing contents, you should change the heat level in
the software.
The settings from the
Print param.
menu and the software are
added together.
The
Heat level
setting also affects the test printouts.

0
Print speed
Basic print speed setting.
The print speed can be re-specified for each print job via software.
The basic setting is not changed by this.
The print speed setting also affects the test printouts.
100 mm/s
Transfer print
On
for thermal transfer printing: Sensor for monitoring the transfer
ribbon is activated.
Off
for thermal direct printing: Sensor for monitoring the transfer
ribbon is not activated.
The setting can be overwritten for each print job via software. The
basic setting is not changed by this.
On
Warn level
ribbon
Warning via the Ethernet interface by way of an SNMP message or
e-mail sent when the remaining diameter of the ribbon supply roll
undershoots the set value (32–74 mm). Off
Ribbon saver
at PX only
JScript
: Ribbon saver can be activated by the software

Programming Manual
On
: Ribbon saver is always active
JScript
Label sensor Method for detecting the starting end of the label.
Gap Sensor
: Detection using changes in the transparency between
the label and label gap.
Bottom-Reflect : Detection using reflex marks on the bottom of the
medium.
Continuous media:
If cutter is not installed, access only with service key
inserted!
Synchronization of the paper flow when using endless media in
cutting mode.
After loading media press the
feed
key.
That way a short feed and a synchronization cut are realized.

Gap
sensor
Tear-off mode Positioning the label medium for tearing off at the tear-off plate.
On
: Additional advancement of the label medium which positions the
label gap after the last printed label at the dispense plate.
Off
: Label advance stops once the last label has fully passed the
print line.
Off

