10
10
3.3
Power Supply of the Device
1
3
5
4
2
Fig. 5
Power supply of the printer and the applicator
!
Attention!
When the power cable is connected the entire current flows through the power supply of the printer. The
power switch of the applicator only affects the powers supply of the applicator.
1. Plug the power cable (2), as part of the contents of delivery, into the plug point of the applicator.
2. Disconnect the plug (4) of cable (3) of the applicator and plug it into the plug point of the printer.
3. Switch on the applicator via the switch (1).
4. Power up the printer.
i
Note!
If only the printer is powered and not the applicator, the error message:
Compressed air error
will be
displayed.
5. To better organize the cables use the self adhering cable clamps (1). These clamps may be freely placed to best
suit the needed support for the cables.
