27
6.6
Setting the Application Height
Dismount the cover
„5.4 Mounting and Demounting the Cover“
Place the product in the product-holder
Switch off the compressed air.
Pull the tubes out of the main cylinder Z-direction to be able to move the pliers manually.
Move the pliers to the product manually.
The upper edge (2) of the pad assembly should be located directly under the lower edge of the product (1).
Design the appropriate bracket.
The center of the product (1) must be perpendicular to the closing plane of the two pads (2).
Loosen the screws (8) at the stopper (4) and screws (9) at the transport lock (3). Pull the Stopper (5) and the
transport lock (3) all the way down to the slide until the shock absorber is fully pushed in.
Tighten screw (8) at the stopper (4) and screw (9) at the transport lock (3).
Fine adjustment by turning the shock absorber (6).
!
Attention!
The transport lock and stop must not hit the carriage (7) directly.
The carriage (7) may only touch the shock absorber (6).
Put the tube back into the main cylinder Z-direction.
Switch on the compressed air.
Mount the cover
„5.4 Mounting and Demounting the Cover“
!
Attention!
The stroke of the main cylinder is braked by the stopper with the shock absorber (5), not by the product!
2
1
2
1
3
4
1
6
5
4
8
9
3
7
Fig. 24
Adjust the application height