12
12
4
Error Messages
4.1
Error Messages of the Printer
For detailed information about printer errors (e.g. 'Paper out', 'Ribbon out', etc.)
Operator's manual of the printer
Error treatment:
Clear the error results
Press the
feed
key to synchronize the label feed, remove the peeled labels manually
Press the
pause
key to quit the error state.
After error correction, the print of the label causing the error will be repeated.
4.2
Error messages of the applicator
The following table contains an overview of error messages and their possible causes. It also suggests methods to
resolve the problem:
Error Message
Possible Cause
Air pressure ins.
Compressed air is switched off
Pressure to low < 4 bar
Pressure ti high > 6 bar
Label not depos.
Label has not been placed onto the product; after the pad has moved back the label still
sticks on the pad.
Lower position
Pad is not in start position if the printer switched on.
Pad has not reached the labeling position within 2s after the movement of the pad was
started
Pad has undefined leaving the start position.
Process Error
Process of labeling was braked via the I/O interface of the printer with the XSTP signal.
Refl. sensor blk.
There has been no change of the switch state at the upper sensor at the cylinder
between the start of the labeling process and the signal from the labeling position sensor.
Vac. plate empty
Label has not been picked up properly by the pad; or label fell off the pad before it could
be placed onto the product.
Upper position
Pad has not reached the starting position within 2s after the pad has left the labeling
position; or pad has left the starting position unauthorized
Table 2
Error messages of the applicator
Error treatment:
Clear the error results
Press the
pause
key to quit the error state.
i
Note!
In fault check adjustments and settings with help of the Service Manual.
!
Warning!
The pad will immediately be moved in the starting position!
Danger of crushing to hand and fingers by the moving pad!
Do not reach into the zone of the moving pad and keep long hair, loose clothes, and jewelry distant.
After error correction, the print of the label causing the error cannot be repeated without re-start of the print job.
In the application mode "Apply/Print" send the signal "Print first label" or press the button
to send a printed
label to the pad.
