Cab Technology PX Series, Руководство по обслуживанию

Страница: 29 / 38

29
5.6 Adjusting the Ribbon Saver Mechanics
The saver automatic reduced the consumption of color ribbon, because in case of the saver mode the movement
will interrupted by lifting the printhead. This operated by a eccentric, which is controlled by a light sensor. A failure in
adjustment is possible if the transport of the ribbon is stopped generally or it will make all movements like the label
material.
Danger!
Risk of death via electric shock!

Before opening the housing cover, disconnect the device from the mains supply and wait at lease one
minute until the power supply unit has discharged.
1 2 3 4a 5 6 5 6 1 4b
Fig. 29 Eccentric in saver mode Fig. 30 Eccentric in print mode
6
7
Fig. 31 Checking distance eccentric - ball bearing
1. Unplug the printer from the electrical outlet.
2. Remove the cover.
3. Lock the printhead.
4. Loosen the screws (2) at the clock wheel.
5. Turn axle (1) in such a way that the eccentrics (6) lift the
printhead via the ball bearings (5) at most

Fig. 29 right side.
6.
Adjust a gap of ca. 1 mm between flange (4a) and the
edge of the sensor housing (3) by turning the clock
wheel

Fig. 29 left side.
7. Tighten screws (2).
8. Turn axle (1) in such a way that there is a gap of 1 mm
between flange (4b) and the other edge of the sensor
housing

Fig 30 left side.
9. Check the distance between ball bearing (5) and
eccentric (6) with the caliber 0.1 mm (7).
10. Mount cover.
5 Adjustments