C-SCOPE Newforce R1, Руководство по эксплуатации

Страница: 15 / 27

14
optimum performance on a particular site. The level is adjusted by rotating the
MENU/SCROLL control. An incorrect setting will result in a fluctuating signal on the RADAR
display and frequent ‘0’ targets on the ID display. To find the optimum ground setting, raise
and lower the head above an area of ground free from any targets then adjust the ground
setting for minimum audio fluctuation and ID indications. An alternative method is to set the
Pin Point gain to 8 and then lower the head to an area of ground free from any targets. If the
audio level increases then decrease the ground setting, if it decreases, (goes quiet), then
increase the ground setting.
NOTE: If BEACH is selected then an incorrect ground setting will result in frequent ID targets
in the range 3 to 6 depending on beach conditions. Adjust the ground setting as described
above.
FREQUENCY
DISCRIM DISPLAY LOW
SENSITIVITY GROUND ADJ MIDDLE
AUDIO FREQUENCY HIGH
PROGRAMS BATTERY
SET UP BACK
This can be used to change the operating frequency of the R1. Three frequencies are
provided. Generally the middle frequency should be used but the others can be used if
interference from other metal detectors is experienced. Use the MENU/SCROLL control to
highlight the desired frequency and the press the ENTER key to store the setting. NOTE: the
frequency does not change until the ENTER key is pressed.
BATTERY
DISCRIM DISPLAY RECHARGE
SENSITIVITY GROUND ADJ ALKALINE
AUDIO FREQUENCY
PROGRAMS BATTERY
SET UP BACK
This option allows the selection of either rechargeable batteries or alkaline batteries. It is
used to ensure that the battery monitor accurately shows the state of charge of the batteries.
Use the MENU/SCROLL control to highlight the desired battery type and then press the
ENTER key to store the setting.