C-SCOPE Newforce R1, Руководство по эксплуатации

Страница: 14 / 27

13
SENSITIVITY OPTIONS USER 2
AUDIO RECALL
PROGRAMS STORE
SET UP BACK
Stores all current settings into the program selected, either USER 1 or USER 2.
SETUP
DISCRIM DISPLAY
SENSITIVITY GROUND ADJ
AUDIO FREQUENCY
PROGRAMS BATTERY
SET UP BACK
DISPLAY
DISCRIM DISPLAY CONTRAST
SENSITIVITY GROUND ADJ BRIGHTNESS
AUDIO FREQUENCY
PROGRAMS BATTERY
SET UP BACK
These options allow the display settings to be adjusted. These settings are stored when the
R1 is switched off and will be restored when it is turned back on. To select, highlight the
desired option by rotating the MENU/SCROLL control and the press the ENTER button.
CONTRAST
This option sets the contrast level or viewing angle of the display. Once set it shouldn’t
require adjustment. However, if the R1 is used at dawn or dusk when the sun is low in the
sky then some adjustment may be required to improve the visibility of the display. The
desired level should be set by rotating the MENU/SCROLL control and then pressing the
ENTER button when satisfied, this will store the setting.
BRIGHTNESS
This option sets the brightness level of the backlight. In normal daylight the backlight is not
required and it should be set to 0. At night or in conditions of poor light the backlight level
should be adjusted by rotating the MENU/SCROLL control and then pressing the ENTER
button when satisfied, this will store the setting. IMPORTANT NOTE: The backlight
consumes a lot of power compared with the low consumption circuitry of the rest of the R1.
For this reason to ensure long battery life the backlight should only be used where
necessary and the brightness level kept to a minimum. The brighter the backlight the more
power it uses and the shorter the battery life will be. When the backlight is on the
symbol appears on the display to prevent inadvertent use.
GROUND ADJUST
DISCRIM DISPLAY
SENSITIVITY GROUND ADJ
AUDIO FREQUENCY
PROGRAMS BATTERY
SET UP BACK
The default setting of 50 is a good general setting and should be adequate for most sites.
However, a fine adjustment is provided to allow the operator to adjust the R1 to give