C.P.Bourg Document Finisher E Series, Руководство оператора

Страница: 40 / 75

Operator Manual
Page 9 - 40
Initial issue: 02/13
Latest revision: -
10.1.3 JDF Mode Selection
Note: JDF mode is only enabled with the optional Bourg JDF Kit.
"JDF never" mode
The finisher set up is made through the GUI attached on the BDF-e. It is the usual way of wor -
king by keying job parameters then validate them to get the finisher ready to receive jobs from
the Printer/Press.
The GUI enables to save jobs and make a recall to save settings time.
"JDF only" mode
The finisher set up is always made automatically by receiving JDF from Ultimate Bindery.
The GUI is switched in JDF mode then manual job settings and pre-defined job recall are
disabled (gray color). After job imposition is made by Ultimate Impostrip and sent to the FFPS
(FreeFlow Print Server) hold queue, Ultimate Bindery consumes the job and sends the JDF to
the finisher.
The JMF (Job Message Format) synchronization between Ultimate Bindery and the Bourg
finisher informs Ultimate Bindery of the finisher status. When the finisher is ready, Ultimate
Bindery releases the job at the FFPS queue and the job is printed and finished.
The automatic mode
The automatic mode enable to make the finisher set up by selecting or defining the job with
the GUI (on BDF-e) and also dynamically by receiving a JDF as described here above.
Press this button to
cancel the job.