Bymat Premiumline 6024 RS, Руководство пользователя

Страница: 6 / 16

Embossing light and dark
To mark decals onto your work piece, set the program to either Embossing Light or Embossing Dark and
select by pressing the control button.
For embossing light or dark the digital display should show 12 Volts. You can adjust the voltage by
turning the control knob accordingly.
Use a strip of the supplied cleaning felt by attaching the strip to the flat (90°) carbon stamp using the
O-ring provided. A template of the decals to be marked is required.
The felt strips will wear with prolonged use. To avoid short-circuiting the machine,
replace worn felt strips accordingly.
The stamp is connected using the accompanying black ground cable to the black connector of the machine.
The red-marked ground wire must be connected to the work piece via the ground clamp.
Moisten the felt uniformly using a little of the correct marking electrolytes.
For embossing dark or light the correct electrolytes for the grade of substrate material needs to be used.
(See Below)
Embossing Dark:
ET - Vanadium Steels
EC - Chrome Vanadium Steels
EM - Brass Copper and Tin
EA - Aluminium
Embossing Light:
EN - All materials
Position the template on the work piece and hold in position by hand or using adhesive tape. Position the
flat end face of the stamp on the area to be marked and then gently slide the stamp across the remainig area
for about 2 - 4 seconds or until the desired marking is achieved.
Remove the template and then remove the remaining electrolyte using a wet cloth. Neutralise the newly
marked surface with a cloth soaked in
Neutralyte.
Then rub a few drops of Preservative .
Tips for handling templates.
Each electrolyte contains salts. The templates can become clogged with these salts.
Therefore, you should clean the templates after every use with
clean water and washing up liquid.
Working with chemicals can lead to hazards. It is required to wear an acid apron,
tightly fitting acid resistant goggles and gloves. It is also required to have sufficient
extraction/ventilation around the work piece or to wear a suitable respirator.
Please refer to the safety data sheets of the individual electrolytes.