Bymat Premiumline 6024 RS, Руководство пользователя

Страница: 4 / 16

User manual Bymat 7024 RS
Commissioning
Connecting the device:
Connect power cable of the Cleaning and Embossing device to an appropriate power source and turn on using
the on/off switch on the back of the machine. The display will then show the start menu. Turn the control knob
to go to the desired program. Press the conrtol knob to select the desired program.
Connect the black wire to the black terminal connector on the front panel and connect the carbon stamp/brush
at the other end.
Connect the ground cable with the red mark on the red socket on the front panel and attach the grounding
clamp to the work piece.
Do not apply any external voltages to the component to be cleaned!
Do not use in wet areas and protect against moisture and splashes!
Cleaning with the carbon stamp
To remove the oxide layer, set the program to cleaning and select by pressing the control button.
For cleaning with the stamp the digital display should show 24 Volts. You can adjust the voltage by
tuning the control knob accordingly.
Use a strip of the supplied cleaning or polishing felt by attaching the strip to the carbon stamp using the
O-ring provided.
The felt strips will wear with prolonged use. To avoid short-circuiting the machine,
replace worn felt strips accordingly.
The stamp is connected using the accompanying black ground cable to the black connector of the
machine. The red-marked ground wire must be connected to the work piece via the ground clamp.
Decant a little of the corresponding electrolyte (
Electrolyte A for light oxide layers) into the wide neck receptacle
provided and immerse the stamp. Slide your stamp on the oxide layer to be treated
until it has all been removed.
After prolonged operation, the stamp may become too warm. If this occurs, cool it
in water bath, or use a second stamp.
Cleaning with the brush
To remove the oxide layer, set the program to cleaning (brush) and select by pressing the control button.
For cleaning with the brush the digital display should show 4 - 12 Volts. You can adjust the voltage
by tuning the control knob accordingly.
Ensure the brush is fitted with a brush head in good condition.
The brush is connected using the accompanying black ground cable to the black connector of the machine.
The red-marked ground wire must be connected to the work piece via the ground clamp.
Decant a little of the corresponding electrolyte (
Electrolyte A for light oxide layers) into the wide neck
receptacle provided and immerse the brush. Brush over the oxide layer to be treated until it has all
been removed.
After prolonged use the brush may become too warm. If this occurs, cool it
in water bath, or use a second brush.