BYD F6, Руководство пользователя

Страница: 64 / 215

F6 OWNER’S MANUAL
61
Power interior rearview mirror
Keep the exterior and interior rearview
mirror clear, and make them has the best
vision angle. Before driving, adjusting is
finished.
It has two modes, day and night. It can
reduce the glare from back vehicle at night.
To change the mode, pull the convex tongue
at the edge of rearview mirror bottom.
The methods and steps to adjust interior
rearview mirror.
1
、
Before adjusting, pay you attention for
the following three points: the direction
which is displayed by the interior rear view
mirror is the vehicle head direction, the state
is normal, under adjusting, the words which
are displayed by the interior rearview mirror
is used to give you a tip, the state is
adjusting state:
You’d better use the clip
；
when adjusting, you should choose a
square
、
closed-loop street or a annular
roadway ( turnplate), and confirm the east 、
south 、 west and north （ as the illustration ） ；
2
、
Adjusting steps:
The first step ： start the vehicle, the words
will be displayed in the top right corner of
interior rearview mirror, the word may be
one of east
、 west 、 south 、 north 、 westnorth 、
westsouth 、 eastnorth and eastsouth
The second step
：
Choose the start direction.
The third step
：
Use clip to press
the“confirm”to enter into adjusting state.
The screen will appear “north” and flash for
two times, and then stop.
The fourth step ： Drive the car for two
circles at a slow speed, less than 8Km/h
(notice: when driving, you can’t make the
car misfire)
The fifth step ： adjusting vehicle head ，
make it point to south. Press the “confirm”,
and the screen appear the “ south”, then
press the “confirm” again, if appear the
“south” and flash for two times, then stop
and the adjusting is finished. It will
automatically quit the adjusting state and
enter into normal state.
Or else, the second times you press
“confirm” and appear the “east”, you should
firstly misfire, and anew adjust it from the
Confirm
确定键
Screen
Screen