GasAlertMicroClip
User Manual
6.
Re-assemble the detector. When assembling the
detector, be aware of the following:
x
Ensure the charging contact pins inside the
rear shell are lined up to its appropriate hole
before inserting the rear shell in place. If the
contact pins are bent, the battery cannot
charge properly.
x
Verify that the battery PCB is in the same
position as when the rear shell was removed
(refer back to step #2).
x
Visually inspect the battery to ensure that it
has not been damaged before replacing the
rear shell.
x
Ensure the rib on the interior of the rear shell
fits between the battery pack and the PCB as
shown in Figure 6.
x
Ensure the rear shell sealing rib is not folded
when replacing the rear shell (see Figure 5).
x
Torque the screws to 3-4 in-lbs in a crisscross
pattern to ensure a proper environment seal.
Figure 6. Replacing the Rear Shell
Calibrate the detector after changing any sensor. See the
section,
Calibration
.
38
