4
Fig. 7
full speed for 2 seconds, then slow down to dialed speed.
5.
To activate the vibrator press the vibrator switch ON. Vibrator
switch will illuminate.
6.
To stop the spreader, push ON-OFF switch to OFF position.
Controller Warnings
Check controller instruction sheet for latest controller updates
and troubleshooting codes. Controller instruction sheet is inside
controller shipping box.
IMPORTANT! INSTALLER, DO NOT DISCARD CONTROLLER
INSTRUCTION SHEET. STAPLE SHEET TO SPREADER
MANUAL AND GIVE TO END USER!
Note:
To unclog auger manually, first remove the chute. Apply
1¼" open wrench on auger’s nut. Turn auger counterclockwise
several times.
Note:
Do not run the vibrator longer than 30 minutes with 15
minutes between runs to avoid overheating.
Material Flow Adjustments
Always use screen during spreader operation! Various
materials have different moisture absorption rate, some
materials may not perform as desired. Therefore, the
substitution of the alternate material may be necessary for
optimum performance.
SHPE1000 has one discharge opening covered with two
adjustable deflectors. To adjust amount of material going
through this opening loose two screws, slide deflectors to
increase or reduce opening exposure. It is recommended
Thoroughly clean battery terminals. Make sure battery
terminals have no tarnish or corrosion.
DO NOT CONNECT WIRE HARNESS TO DAMAGED
OR CORRODED TERMINALS! IT MAY RESULT IN
OVERHEATING, LOST POWER AND POTENTIAL
CONTROLLER DAMAGE!
G.
Attach utility light (optional) to spreader hopper in desired
location. Connect as shown in Fig. 7. Use utility light kit part
number 3018009.
H.
See controller instructions for latest updates and error
codes.
Spreader Operation
1.
Different materials absorb moisture at different rates and
some materials may not perform as desired. Subsitution
of an alternative material may be necessary for optimum
performance.
2.
When filling hopper use the supplied screen to prevent large
chunks of material and debris in the material to get into hopper
and cause damage.
3.
Material must never be left in hopper for an extended
period of time. Material will absorb moisture, bind, harden
and could prevent spreader from proper operation or may
damage the spreader.
4.
The SHPE1000 spreader is equipped with a dual independent
speed controller with warning indicators and a vibrator switch.
To start the spreader, press the ON-OFF switch. Switch will
illuminate. The auger will accelerate to full speed for 2 seconds,
then slow down to dialed speed. The spinner will accelerate to
3014199
3006724
3035933
CB120PB
3001379
BATTERY POSITIVE
BATTERY NEGATIVE
