Butternut HF9V, Инструкция по эксплуатации

Страница: 6 / 24

-6-
ASSEMBLY
45. Measure from the rivet of wire clamp 0.500" 15 M w/wire (L) to a point 11 ft
3 in (3.4 m) along the stranded wire and mark this point.
46. Pass the free end of the stranded wire from wire clamp 0.500"
15 M w/wire (L) through the small holes in wire clamp 0.625"
15 M w/insulator (M) and wire clamp 0.750" 15 M w/insulator
(N) as shown.
47. Loop the end of the wire through the hole in wire clamp 0.875"
15 M w/insulator (K) sliding it on tube (F) until the mark on the
wire appears. Wind the wire back on itself. Do not cut off the excess wire.
48. Line up wire clamp 0.875" 15 M w/insulator (K), wire clamp 0.750" 15 M
w/insulator (N) and wire clamp 0.625" 15 M w/insulator (M) with wire clamp
0.500" 15 M w/wire (L) and tighten all clamps making sure the wire is
moderately taut but not enough to cause the upper tubing section to bow.
49. Place the protective cap on one end of tube (J).
50. Slide the uncapped end of tube (J) into the slotted end of tube (I) until only 25
in (63.5 cm) extends and secure with compression clamp small adjustable.
NOTE: In the following steps the antenna will be assembled and
raised to its full vertical height. If the antenna is to be installed in
an elevated position where it is unsafe or inconvenient to make
in-place adjustments, the antenna may have to be installed in one
piece. It will probably be necessary to raise and lower it and its
supporting structure a number of times to arrive at the ideal
adjustment on all bands. If so, every precaution should be
observed in order to avoid possible contact with power lines and
to prevent structural failure that can cause injury to persons or
property.
51. Place the lower end of tube (B) through tube (E) over the insulator on tube (A)
w/insulator. Line up the holes and secure it with a # 8 x 2" screw, lock
washer and hex nut.
WARNING: AVOID POWER LINES!
52. Raise the assemble of tube (F) through tube (J) and slide the lower end into
tube (E) fastening it securely with a # 8 x 1 1/4" screw, lock washer and hex
nut.