Butternut HF9V, Инструкция по эксплуатации

Страница: 3 / 24

-3-
ASSEMBLY
NOTE: The outer tab of this clamp may be bent back slightly to
provide clearance for the bolt, bending it back into place after
assembly.
8. Stretch the 40 meter (smaller) coil on the coil assembly 80/40 meter (C) until
the top of the upper clamp is even with the upper mark. Secure with a #10
flat washer, lock washer and wing nut.
9. Stretch the 80 meter (larger) coil on the coil assembly 80/40 meter (C) until
the bottom of the lower clamp is even with the lower mark. Secure with a
#10 flat washer, lock washer and wing nut.
10. Locate the capacitor assembly 80/40 meter (D) and install capacitor bracket
80 meter (D1) on the larger 200 pF capacitor using the installed screw.
NOTE: DO NOT USE EXCESSIVE FORCE OR OVER TIGHTEN THE
SCREWS ON EITHER CAPACITOR AS YOU WILL DAMAGE THEM.
DO NOT DROP THIS ASSEMBLY AS YOU MAY FRACTURE THE
CAPACITOR’S CERAMIC SHELL.
11. Locate capacitor bracket 40 meter (D2) and install on the smaller 67 pF
capacitor as above.
12. Install the above assembly onto the #10 screw protruding from the tab of the
center clamp on the coil assembly 80/40 meter (C). Align capacitor bracket
80 meter (D1) alongside the larger 80 meter coil of coil assembly 80/40 meter
(C). Secure with a #10 flat washer, lock washer and hex nut.
13. Attach the tab end of capacitor bracket 80 meter (D1) to tube (B) with
capacitor bracket clamp and secure with # 8 x 1" screw, lock washer and a
hex nut.
14. Attach the tab end of capacitor bracket 40 meter (D2) to tube (B1) as above.
15. Insert the un-slotted end of tube (E) into tube (B1) and secure with a # 8 x 1
1/2" screw, lock washer and hex nut.
16. Locate coil support tube 30 meter (O) and measure to a point 9 7/8 in (25.1
cm) down from the plastic insulator. Mark this point with a pencil.
17. Locate coil support tube 30 meter L bracket (O1) and place the tabbed end
inside of the coil support tube 30 meter (O) securing it with a # 8 x 3/4"
screw, lock washer and hex nut.
18. Place a #10 washer, lock washer and wing nut on the lower single clamp of