Butterfly B1201B, Руководство пользователя

Страница: 17 / 87

P a g e | 17
Butterfly B1201B/T - Single Head 12 Needle Embroidery Machine Manual
thread breaks. If your machine is giving false thread breaks, first check that this wheel is properly
threaded. If this wheel is properly threaded, check the entire thread track for any misthreading.
Step 11 – Place thread over the rotary wheel and then to the right of the wheel and then to the
left of the next thread guide rod. If your machine is detecting false thread breaks but threaded properly,
you might try wrapping the thread around the rotary wheel a second time.
Step 12 – Place thread under the next thread guide.
Step 13 – Open the head case cover. To the right of the machine behind the cover, on the head,
there is a lever that goes up and down. Push the lever down as far as it goes. When you do, you will see
several (12) small wires/springs. These are known as the Check Springs .
Step 14 – Place the thread to the right of the right most cylinder rod where check springs come
out of when the check spring lever is pressed down. Place the thread through the check spring eyelet
from the right to the left. Bring the thread back up to the left of the leftmost rod corresponding to the
current thread you are threading. Move the lever so that the checks springs go back up all the way and
then bring it back down about 1mm to give the springs a little bit more spring than if they were all the
way up. Not placing the check springs in the correct position will cause trimming problems and
problems when changing colors.
Step 15 – Bring the thread back up about 3 inches into the take up lever eyelet.
Step 16 – Bring the thread back down, past the check spring to the bottom of the head and
through the last thread guide/eyelet
Step 17 ‐ Place the thread through the needle eye from the front to the back. It is
recommended that you cut the thread at a 45 degree angle to give it a point. Once you cut the thread,
use your fingers to straighten out the end. Hold the thread with your index and thumb leaving about 1 –
1 ½ inches out keeping the thread at straight as possible as you pass it through the needle. Once thru
the needle, pass it through the needle bar hole.
Step 18 – Place the thread in between the long spring at the bottom of the machine. There is no
need to wrap it in the spring and it is recommended placing it into the spring gently without much
tension. The spring is only used to temporarily hold the thread. Cut the thread at the end leaving about
1/3 inch extra.
Step B – Continue with the next spool of thread, threading in the same manner as the previous
thread.
Further examples are shown on the next page.