Bushranger L2600, Руководство оператора

Страница: 8 / 24

8
ASSEMBLY
Installing Plastic Shield
Install the safety cover on the
shaft with the safety cover
bracket and the screws provided.
Tighten the screws after setting
the safety cover bracket at the appropriate
position. (Fig. 1 ).
WARNING / CAUTION
Installing Nylon Line Cutter
Head
• Align hole in adapter plate
with hole in shaft and install
locking tool. (Fig. 2).
• Thread cutter head onto shaft (turning it
clockwise) until it is tight. Looking from the top.
Installing Handle - Place the
upper ‘D’ handle (Fig. 3) over
the outer tube into the desired
position, then while holding the
bottom half of the handle in
place insert the 4 screws and
tighten with the allen key provided.
WARNING / CAUTION
If there is excessive vibration - stop engine
immediately.
RULES FOR SAFE OPERATION
WARNING / DANGER
All model trimmers and brush cutters can throw
small stones, metal or small objects as well as
the material being cut. Read these Rules for Safe
Operation with care.
Follow the instructions in your operators manual.
Read the operator’s manual carefully. Be
thoroughly familiar with the controls and proper
use of the unit. Know how to stop the unit and
shut off the engine. Know how to unhook
a harnessed unit quickly.
Never allow anyone to use the unit without proper
instruction. Be sure the operator wears foot, leg,
eye, face and hearing protection. Do not rely on
the debris shield on the unit to protect your eyes
from ricocheting or thrown objects. Keep the
area clear of bystanders, children and pets. Nev-
er allow children to operate or play with the unit.
WARNING / DANGER
In addition to head, eye, face and ear protectors
shoes should be worn to protect your feet and
improve your footing on slippery surfaces. Do
not wear ties, jewelry, or loose, dangling clothing
which could be caught in the unit. Do not wear
open-toed footwear, or go barefoot or bare
legged. In certain situations you must wear total
face and head protection. Pay attention to kick
back and blade thrust.
Do not allow anyone to enter the operating
Danger Zone
with you.
Choke - the choke control is located on the side of the filter cover. COLD STARTS. Pull lever up to
close choke for cold starts. Push lever down for RUN position.
Debris Shield - Mounted just above the cutting attachment. Helps protect operator by deflecting
debris produced during the trimming operation. Do not operate unit without shield.
Cut Off Knife Trims nylon filament to the correct length - 7” (178mm), head to end of line-when nylon
trimming head is bumped on the ground during operation, line advance. If trimmer is operated without
a cut-off knife the line becomes too long (more than 7” (178mm)) the operating speed will slow down
the engine, this will overheat or damage the engine.
Nylon Cutter Head - Contains replaceable nylon trimming line that advances when the trimmer head
is tapped against the ground while the head is turning at normal operating speed.
Attaching
Screws
Attaching
Screws
Fig. 1
Fig. 2
Fig. 3