10
• To ensure the line will not
unravel, slip each end into
the slot/lug on the bottom
edge of the spool (Fig.
12).
• Insert the trimmer line into
the slots located on
the side of the spool
housing (Fig. 13).
• When in the correct
position pull the line
ends further (to unlock the line from spool) out
of the housing. Then replace the securing lid
until it clicks into the base (Fig. 14).
WARNING / DANGER
Only use an approved steel blade on this Straight Shaft Brush Cutter.
Scalping and Edging (Refer to Fig. 7 & 8, page 9).
Both of these are done with the line head tilted at a steep angle scalping is removing top growth leaving
the earth bear. Edging is trimming the grass back where it has spread over a sidewalk or drive way.
During both edging and scalping, hold the unit a steep angle and in a position where the debris, and
any dislodging dirt and stones will not come back towards you even if it ricochets off the hard surface.
Although the picture shows how to edge and scalp every operator must find the angles which suit your
body size and cutting situation.
WARNING / DANGER
Do not trim in any area where there are strands or fencing wire. Wear safety protection. Do not cut
where you cannot see what the cutting device is cutting.
REPLACING/FITTING BRUSHCUTTER LINE
• Locate and depress the
two retaining lugs that are
holding the nylon head
together. Seperate the lid
from the base and remove
the spool. (Fig. 10).
• Take approximately 4 -5
metres of good quality 2.4
or 2.7mm diameter trimmer
line. Fold in half and make a
loop. Hold the spool in one
hand and hook the line into
the slot with the other hand.
• Wind both lines
anti-
clockwise
on both sides
of the spool ensuring that
both lines remain in their
respective channels (Fig. 11).
ATTACHING CUTTING BLADE
• Metal Blade can only be fitted to a Straightshaft
Brushcutter (Fig. 15).
• If heavy material is needed to be cut use the
supplied metal blade.
• Remove the nylon cutting head. Then fit the
cutting blade as shown in the two photos
attached (Fig 15A & 15B).
• Remove nylon head opposite to fitting
instructions.
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Fig. 15A
Fig. 15B
Содержание L2600
