5
4
GETTING STARTED
Installing Batteries
This device operates on two AA batteries. To install, unscrew
the battery compartment cover located on the bottom of
the unit. Insert the batteries into the battery compartment
so that the (+) and negative (-) terminals of the batteries
match the markings inside the compartment. Replace the
battery cover carefully – do not over tighten.
Use and Testing
This device operates on two AA batteries. Make sure they
have been installed according to the instructions above.
If you wish to test your night vision device in a lighted area,
be sure the objective lens cap is covering the objective lens
(1) prior to pressing the “ON” button (2). The objective lens
cap has a pinhole opening to admit a small amount of light
for testing purposes.
If testing or using the device in the dark, remove the
objective lens cap and activate the device by pushing the
“ON” button (2).
Set the preliminary focus adjustment by placing the adjusting
mark (located on top of the objective focusing ring) opposite
the letter “N” in the word “Normal” (6).
Your Night Vision device offers a Built-In Infrared Illuminator.
This allows you to see in complete darkness where no
ambient light source, such as moonlight, is available. To
activate, simply press the button (3) located next to the
“ON” button.
Direct the device at an object at a distance approximately 100 yards and rotate the eyepiece (4) to give the best quality image.
After the adjusting, do not rotate the eyepiece any longer irrespective of the distance and other conditions.
Direct the device at the subject to be viewed and adjust the final focus by rotating the objective lens focusing ring until the
image quality is optimal.
The Green LED indicates that the light amplifier unit is on. The Red LED indicates that the Infrared Illuminator is on. Always
remember to turn the unit off when done. Do not store this device while the indicators are lit. This device can be mounted on
any tripod with a 1/4“ tripod socket (5).
