REVIEWING THE MARKINGS
The capacity of each coil lifter is listed on the identification plate which is located on the inside face of
the frame.
The live load plus the weight of the lifter (also listed on the identification plate) cannot exceed the
rated capacity of the crane. To prevent accidents to personnel and equipment, never exceed the
maximum load capacity.
Operators must be familiar with all safety and identification decals and maintain them in a clean and
legible condition. If new decals are required, call the factory for free replacements. Refer to the
Identification and Safety Standards, page for markings
BECOMING FAMILIAR WITH THE LIFTER
Before operating the coil lifter, review this safety manual.
The lifter is shipped completely assembled except for electrical connections. Take particular note of
all safety warnings and safety decals before making electrical connections.
If electrical controls are furnished with the lifter, refer to the wiring diagram provided. Always
disconnect power at source before servicing the lifter. When connecting lifter to power supply, be sure
to follow approved lockout/tagout procedures as outlined in ANSI Z244.1. Only qualified personnel
should install and/or service this lifter.
Coil lifters are furnished with an adjustable clutch on the reducer output shaft. Before putting the
lifter into service, test it with a test load and adjust the clutch with the spanner wrench to eliminate
excess slippage. Caution: Do not over tighten the clutch. This may result in damage to the drive
components.
Refer to clutch adjustment instructions in this manual.
Before operating lifter, replace reducer solid pipe plugs with vent plugs provided and check the oil level
in both reducers. Use lubricant specified by reducer manufacturer.
Warning: Coil lifters are large and top-heavy; they can cause personal injury or property damage if
they fall over. When not in use each coil lifter should be stored on a stand designed for its specific
size and weight by the factory or a qualified engineer.
