MAINTENANCE
PHDHF / PHDHC 03/20
Maintenance Section 5-3
© 2020 Alamo Group Inc.
M
A
IN
TE
N
A
N
C
E
AUGER MAINTENANCE
Inspect auger to loose, worn, broken and missing cutting teeth and points. Worn teeth and points can greatly
affect auger penetration and greatly reduce auger life expectancy. Always keep spare teeth and points on
hand. Some digging may require inspecting teeth and point condition more frequently.
On rock augers, inspect the wear of hardfacing. If worn away, re-hardface surface immediately. Failure to
maintain hardfacing will allow excessive wear on pockets and will ruin auger.
MACHINE INSPECTION
CHECK DRIVE UNIT AND ALL ACCESSORIES DAILY
Inspect the drive unit and all accessories daily for loose, bent, cracked, or worn bolts or fasteners. Always use
grade 5 or harder replacement bolts. Always use lock washers with standard hex nuts or lock nuts.
Repair or replace any worn parts immediately. Remember that drilling applicant can be hard wor, for any
machine. Under extreme conditions parts can wear or break. Using any machine without proper maintenance
of all parts can cause further damage to good parts.
Check to ensure that all pins and bolts are secured in place and are tightened to the proper torque.
STORAGE
Your rotary mower represents an investment from which you should get the greatest possible benefit.
Therefore, when the season is over, the implement should be thoroughly checked and prepared for storage so
that a minimum amount of work will be required to put it back into operation for the next season. The following
are suggested storage procedures:
1. Thoroughly clean the implement.
2. Lubricate the implement as covered in Maintenance Section.
3. Tighten all bolts and pins to the recommended torque.
4. Check the implement for worn or damaged parts. Make replacements immediately.
5. Store the implement in a clean, dry place with the implement housing resting on blocks.
6. Use spray touch-up enamel where necessary to prevent rust and maintain the appearance of the
implement.
Содержание PHDF20-2
