Bush Hog HT210, Руководство оператора

Страница: 28 / 62

ASSEMBLY
HT210
06/17
Assembly Section 3-2
© 2016 Alamo Group Inc.
A
SSE
MB
LY
GENERAL ASSEMBLY
Your new HT210 Tedder is shipped partially assembled. Some assembly procedures described here may have
been completed. Layout all components before starting and familiarize yourself with the parts by referring
yourself to the parts breakdowns in this manual.
Assembly is highly dangerous and must be carried out in strict accordance with the following instructions. We
recommend that qualified personnel perform assembly. It is highly recommended that assembly be carried out
in a flat, solid surface, open area with no people (particularly children) nearby who could be severely be injured
if they were to touch or move any parts of the machine.
When assembling the implement provide suitable lifting mechanisms and supports to stabilize the partially
assembled implements. This will prevent them from falling and causing damage to the implement or serious
injury. The steps for assembly are illustrated in the following pages. Depending on the experience of the
assemblers and the tools available, it is not necessary that the instructions be followed in the exact order given
here, but the safety precautions described above must always be followed carefully and scrupulously.
Make sure the area around the machine is clear before lowering the wings. Do not lower the
tedder wings when people or pets are near the rotary tedder or folding mechanism. The
tedder must be attached to the tractor when the wings are folded.
Always use safety stands or blocking in conjunction with hydraulic jacks or joists. Do not rely
on the jack or joist to carry the load. They could fail.
AXLE INSTALLATION
1. Position the mainframe upside down as
indicated in Asm-HT-0001.
2. Rotate the gearbox rotors (1 & 2) so that one
disc's holes line up with the main axis of the
frame (7) while the other disc's holes are
spaced equal distance from the mainframe (5 &
6).
3. Remove the roll pin from the gearbox spindle
and discard the spacer. Install axle on spindle
as indicated on Asm-HT-0001, and fasten axle
to spindle using large roll pin previously
removed and second roll pin driven through the
center of the larger roll pin.