BUSCH MINK MV 0040 D, Инструкция по эксплуатации

Страница: 25 / 32

Troubleshooting | 11
0870221625_MV0040-0080D_-0000_IM_en_MD 25 / 32
IS
Problem Possible Cause Remedy
The machine does not start. The motor is not supplied
with the correct voltage.
• Check the power supply.
The motor is defective. • Repair the machine (con-
tact Busch).
The machine does not
reach the usual pressure on
the suction connection. The inlet screen (IS) is par-
tially clogged. • Clean the inlet screen
(IS).
The inlet filter cartridge (op-
tional) is partially clogged. • Replace the inlet filter
cartridge.
Internal parts are worn or
damaged. • Repair the machine (con-
tact Busch).
The machine runs very
noisily. Oil level too low. • Top up oil.
Defective bearings. • Repair the machine (con-
tact Busch).
The machine runs too hot. Insufficient cooling. • Remove dust and dirt
from the machine.
Ambient temperature too
high. • Observe the permitted
ambient temperature,
see
Technical Data
[ ► 29] .
Temperature of the process
gases at the inlet too high. • Observe the permitted
gas inlet temperature,
see
Technical Data
[ ► 29] .
Oil level too low. • Top up oil.
For the solution of problems not mentioned in the troubleshooting chart contact your
Busch representative.