32
I-Modell - 07/07 - Ausgabe 03/07 - 1512317 - BUE-0056-00EN
During the journey
4
4.2
Parking distance control (partially special equipment)
Short description
The parking distance control serves as an aid for parking. The distance is
measured by the ultrasonic echo sounder method. The distance is calculated
during the runtime of a reflected ultrasonic signal.
In the passenger compartment, an operating unit with a display (Fig. 11)
shows the distance to the obstacle. At the same time, an acute signal sounds
as a warning.
There are two ways to activate the parking distance control:
Activating by going into
reverse gear:
Switch on the ignition and start the engine.
Go into first gear.
The display illuminates and an "ON" appears in the display. The parking
distance control is ready to measure.
Activating by pressing the
On/Off key on the operating
unit:
Press On/Off key (Fig. 11,2).
The display illuminates and an "ON" appears in the display. The parking
distance control is ready to measure.
Switching off:
The parking distance control can be switched off at all times independent
of the selected switch-on method using the On/Off key (Fig. 11,2).
Distance display
The distance between the vehicle and the obstacle is issued in three ways:
The display (Fig. 11,4) shows the distance in steps of 5 cm. The lowest dis-
tance measured by a sensor is shown. What sensor delivers the measurement
is shown by the illumination of the corresponding position LED (Fig. 11,1).
Be particularly careful when driving backwards. Risk of accident and
injury.
The parking distance control is only an auxiliary appliance and may not
necessarily recognise all obstacles. The driver of the vehicle is respon-
sible for safety. If the device fails or there is a malfunction and damage
occurs, then claims cannot be asserted against the vehicle manufac-
turer.
Fig. 11
Parking distance control oper-
ating unit
1
Position LED
2
On/Off key
3
Distance display
4
Display
When you switch on the ignition, the parking distance control carries out
the system check independently. During this, all LEDs and segments (bars
on the display) light up briefly and a beep signal is heard. If, after the
system check, the red LED of the distance display (Fig. 11,3) flashes and
a fast repeating warning tone is heard, the system has recognised a sensor
defect. The defective sensor is shown on the display (Fig. 11,4).
Содержание Goldie
