Burstner Goldie, Руководство пользователя

Страница: 116 / 232

116
I-Modell - 07/07 - Ausgabe 03/07 - 1512317 - BUE-0056-00EN
Appliances
9
230 V electrical operation
Switching on: Set the sliding switch (Fig. 117,7) to the required output level.
Turn the temperature control knob (Fig. 117,1) on the operating unit to the
desired heating level.
Set sliding switch (Fig. 117,3) to either "Heater and hot water" (Fig. 117,4)
or to "Hot water" (Fig. 117,2).
Switching off: Set the sliding switches (Fig. 117,3 and 7) to "0".
Gas and 230 V electrical
operation
Switching on: Open the regulator tap on the gas bottle and the gas isolator tap "Heater/
boiler".
Set the sliding switch (Fig. 117,7) to the required output level.
Set sliding switch (Fig. 117,5) to gas operation.
Turn the temperature control knob (Fig. 117,1) on the operating unit to the
desired heating level.
Set sliding switch (Fig. 117,3) to either "Heater and hot water" (Fig. 117,4)
or to "Hot water" (Fig. 117,2).
The red indicator lamp (Fig. 117,6) goes on whenever a fault occurs.
Switching off: Set the sliding switches (Fig. 117,3, 5 and 7) to "0".
Close the gas isolator tap "Heater/boiler" and the regulator tap on the gas
bottle.
Alde heat exchanger
(special equipment)
The heat exchanger can be used to heat the living area of the vehicle during
travel without operating the hot-water heater in the living area.
The heat exchanger is connected to the vehicle engine's cooling circuit and
thus has the same function as the vehicle heater.
Heat output is set with the living area's heating regulator.
The heat exchanger stop cock is located directly on the exchanger.
If gas and 230 V electrical operation is selected and if the vehicle is con-
nected to the 230 V power supply, then the hot-water heater at first only
operates in 230 V electric operation. Only if the heat output is insufficient
does the gas operation also automatically switch on.
The heat exchanger only works when the vehicle engine is running.
If the heat exchanger is not being used (as in the summer), the heat
exchanger on the stop cock should be shut off.