32
TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
running time and output of the main fan
during the ignition of the initial portion of
pellets.
Principle of operation:
After feeding the initial portion of pellets,
the heater operates for 3 minutes , and
the main fan is turned on at
5%
of its
capacity and operates for 2 minutes (the
heater continues to work). After the two
minutes have expired, the fan starts to
work at
15%
of its capacity and continues
at that level for 3 minutes. If upon the
expiration of that period the photosensor
detects the presence of stable flame, the
burner enters into operating mode. If no
stable flame is present, the burner feeds
in pellets again and repeats the process.
Select the desired option using the
navigation arrows. Use the „
Enter
” button
to open the next parameter. Use the „
F
”
button to open the next page of the menu.
10.3.4. Burn Level
The burner has
three main levels of
burning (three main
output modes of
operation). Use this
menu to set the temperature differences
at which the burner will shift from higher
output mode to lower (step modulation).
Example:
We have set maximum
temperature of
85°С
. Upon reaching
77°С
, the burner will shift down to lower
mode of operation (
two flames
). Upon
reaching
82°С
, the burner enters into still
lower mode of operation (
one flame
).
Upon reaching
85°С
, the burner enters
into suspend mode (
Suspend
).
Select the desired option using the
navigation arrows. Use the „
Enter
”
button to open the next parameter. Use
the „
F
” button to open the next page of
the menu.
10.3.5. Setup of burning Level
This
submenu
allows you to adjust
the parameters of
the
main
mode of
o p e r a t i o n
Maximum output
of the burner. It is
indicated by three flames
.
You can modify the pellet quantity (Feed),
time interval at which these pellets are
fed (Cycle) and fan output as a percentage
value (FAN).
Example:
with the period set at 20
seconds, the pellet auger runs for 13.1
seconds feeding pellets in the burner, and
is off for 6.9 seconds.
Select the desired option using the
navigation arrows. Use the “
Enter
” button
to open the next parameter. Use the “
F
”
button to open the next page of the menu.
In this submenu you
can
adjust
the
parameters of the
medium
output
mode of operation
of the b
urner.
It is indicated by two flames
.
We recommend to set at 50% of the main
mode.
You can modify the pellet quantity (
Feed
),
time interval at which these pellets are
fed (
Cycle
) and fan output as a percentage
value (
FAN
).
Example:
with the period set at 20
seconds, the pellet auger runs for 8,3
seconds feeding pellets in the burner, and
is off for 11,7 seconds.
Select the desired option using the
