4
TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
1.2.2.
Instructions to installation user
DANGER of intoxication or
explosion
Toxic gases may be discharged
when burning waste, plastics,
liquids.
- Use only the fuels indicated in this
manual.
- In case of danger of explosion,
ignition or discharge of exhaust
gases in the room, stop the pellet
burner from operation
.
CAUTION! Danger of injury
/ damage of system due to
incompetent operation.
- The boiler must be serviced only
by persons familiar with the
operation manual.
- As user, you are only allowed to
start the boiler up, adjust the
temperature of the boiler, shut
the boiler down and clean it.
- Unattended children must not be
allowed access to premises with
running boiler inside.
It is mandatory to assure a backup
power generator of corresponding
rated power! (see 12.1)
Safety rules for user operation:
- Operate the pellet burner on
recommended fuel only, and to that end
you must regularly inspect the boiler
room.
- Do not use both cameras for burning
fuel at the same time. Before starting
the boiler, make sure there is no residual
fuel in one of the two cameras and / or
burner.
- Do not use flammable liquids for ignition
or increase of burner output.
- Collect ash in lid-covered fireproof
containers.
- Clean the burner surface using non-
flammable agents only.
- Do not place flammable objects onto
the burner housing and heating boiler
cabinet or in their proximity. (see
diagram 1 for the minimum clearances)
- Do not store flammable materials in the
boiler room.
-
Boilers, chimneys and other connections
of mounted burner must meet standards
for fire and emergency safety of the
country.
- It is mandatory to strictly observe
instructions for connecting the burner
to power network as well as to all
peripherals.
- Structural changes to Dual-chamber
boiler by user can cause damage to
equipment or injury.
- Do not allow contact transmission of
electrical wire or touch any part of the
boiler, where the surface temperature
can exceed 70°C.
- This manual should be kept throughout
the lifetime of the boiler.
CAUTION! Hot surface!
Risk of burns if you touch the
running system. Burner housing,
body and flange are hot surfaces
during burner operation.
-
It is strictly prohibited to open
boiler inspection doors with the
burner running.
-
Close and buckle-lock the hopper
hatch cover after filling the boiler
with fuel. The hopper hatch cover
is not allowed to remain open for
longer periods of time.
-
Also, exercise caution when
touching the observation port for
monitoring the burning process.
It may be hot.
