6
Figure 4: Operating Instructions, EP Ignition System
81460048R3
TO TURN OFF GAS TO APPLIANCE
3. Turn off all electric power to the appliance if service is
1. Set the thermostat and all operating controls to the
to be performed.
OPERATING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE OPERATING
WARNING:
causing property damage, personal injury, or loss of life.
If you do not follow these instructions exactly, a fire or explosion may result
RM7890
RESET SAFETY
SWITCH BUTTON
ELECTRONIC
CONTROL
PANEL
MAIN GAS ROCKER
SWITCH
MAIN POWER
ROCKER
SWITCH
Open manual main shut-off valve(s).
2. Close manual main shut-off valve(s) and pilot valve(s).
2. Set the thermostat or operating control to the lowest setting.
1. STOP! Read the safety information above on this label.
3. Turn off all electric power to the appliance.
10. EP SYSTEM
See control location diagram. On the electronic control
4. EP SYSTEM: Flip both rocker switches to "O" position (off).
5. This appliance is equipped with an ignition device
which automatically lights the pilot. Do not try to light
the pilot by hand.
panel, flip the main power rocker switch to "l" position
(on). The "POWER" status indicator will light.
The pilot will light electronically. If pilot failure occurs,
the "ALARM" indicator will light. In case of pilot
failure, proceed to step 11.
On the electronic control panel, flip the main gas valve
rocker switch to "l" position (on). The "MAIN" gas valve
indicator will light. Main burners will operate.
"MAIN" gas valve indicator will cycle on and off at the
same time as the thermostat or operating control and
the main burners.
8. Turn on all electric power to the appliance.
9. Set the thermostat or operating control to desired
setting.
11. If the appliance will not operate, follow the instructions
"TO TURN OFF GAS TO APPLIANCE" and call your
service technician or gas supplier.
CONTROL LOCATION DIAGRAM
If you cannot reach your gas supplier, call the
B. Do not use this appliance if any part has been under
control system and any gas control which has been
to inspect the appliance and to replace any part of the
water. Immediately call a qualified service technician
phone in your building.
Do not try to light any appliance.
Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
Do not touch any electric switch; do not use any
WHAT TO DO IF YOU SMELL GAS:
BEFORE OPERATING
some gas is heavier than air and will settle on the floor.
area for gas. Be sure to smell next to the floor because
C. smell all around the appliance
which automatically lights the pilot. Do not try to light
A. This appliance is equipped with an ignition device
the pilot by hand.
under water.
fire department.
6. Make sure the manual main shut-off valve(s) and pilot
valve(s) have been shut off for at least five minutes.
Then smell for gas, including near the floor.
7. Open the manual pilot valve(s)
lowest setting.
