4
7. Wait five (5) minutes to clear out any gas. Then smell
If you do not follow these instructions exactly, a fire or explosion may result
If you cannot reach your gas supplier, call the
explosion.
Force or attempted repair may result in a fire or
don't try to repair it, call a qualified service technician.
D. Do not use this appliance if any part has been under
control system and any gas control which has been
to inspect the appliance and to replace any part of the
water. Immediately call a qualified service technician
FOR YOUR SAFETY READ BEFORE OPERATING
position to "OFF". Make sure knob rests against stop.
Never use tools. If the knob will not turn by hand,
C. Use only your hand to turn the gas control knob.
3. Rotate gas control knob clockwise from "ON"
to be performed.
1. Set the thermostat or operating control to the lowest setting.
2. Turn off all electric power to the appliance if service is
GAS
INLET
GAS CONTROL KNOB
SHOWN IN "OFF" POSITION
TO TURN OFF GAS TO APPLIANCE
POSITION
INDICATOR
ON
OFF
phone in your building.
Do not try to light any appliance.
Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
Do not touch any electric switch; do not use any
WHAT TO DO IF YOU SMELL GAS:
WARNING:
BEFORE OPERATING
4. This appliance is equipped with an ignition device
gas is heavier than air and will settle on the floor.
for gas. Be sure to smell next to the floor because some
B. smell all around the appliance area
which automatically lights the pilot. Do not try to light
A. This appliance is equipped with an ignition device
3. Turn off all electric power to the appliance.
1. STOP! Read the safety information above on this label.
2. Set the thermostat or operating control to lowest setting.
the pilot by hand.
OPERATING INSTRUCTIONS
for gas, including near the floor. If you smell gas,
under water.
causing property damage, personal injury, or loss of life.
fire department.
81460028R6
supply pipe going into the
knob is the gray or brown
5. Locate the gas control
valve at the end of the gas
boiler. The gas control
of the gas control valve.
plastic knob located on top
which automatically lights the pilot. Do not try to
light the pilot by hand.
6. Rotate gas control knob clockwise from "ON"
position to "OFF". Make sure knob rests against stop.
STOP! Follow "B" in the safety information above on
this label. If you do not smell gas, go to the next step.
8. Rotate gas control knob counterclockwise from
not force.
"OFF" to "ON". Make sure knob rests against stop. Do
9. Turn on all electric power to the appliance.
10. Set thermostat or operating control to desired setting.
11. If the appliance will not operate, follow the
and call your service technician or gas supplier.
instructions "TO TURN OFF GAS TO APPLIANCE"
Figure 2: Lighting Instructions, EI Intermittent Ignition System
USA Only: 5006B thru 5009B
