Burkert 323219, Быстрый старт

Страница: 14 / 41

14
Operating
Information about the communications software:
The switching position of the DIP switch has priority
over the communications software.
If the values of the sealing function (CUTOFF) or the
correction characteristic (CHARACT) are changed via the
communications software, the corresponding function
must be active (DIP switch set to ON).
The effective direction of the set-point value (DIR.CMD)
can be changed via the DIP switches.
7.2.3 LED display
LED 1
LED 2
Fig. 6: LED display
7.2.4 Device status display
The LED 1 (RGB) show the device status.
The user can set the following LED modes for the display of
device status and valve position.
•
Valve mode
•
Valve mode with error messages
•
Valve mode with error messages and warnings (factory setting)
•
NAMUR mode
•
LED off
The LED mode and the colors of the valve position can be set
with the Bürkert Communicator.
IO-Link:
The LED mode and the colors of the valve position can be also
set with an acyclic parameter (see parameter list).
The description for setting the LED mode can be found in
the section "Setting the LED mode, device status" in the
operating manual.
Type 8791 REV.2
english