9
Factory Defaults
This function allows the operator to reset the grinder to factory settings. To access Factory Defaults:
1. Ensure machine is powered on.
2. Access programming.
3. The first screen should read “NAME HOPPER”. Use the right hidden button to navigate to “SERVICE”.
4. At the “SERVICE” screen, press
SELECT
.
5. The next screen will read “TEST OUTPUTS”. Press the right hidden button to navigate to “Factory Defaults”.
6. Press
SELECT
to enter this option.
Burr Adjustment
The grind can be set from very fine to very coarse. The amount may be adjusted for use in most commercial
coffee brewers. The following procedures should be used to make adjustments. A change in the burr adjust-
ment will also change the amount dispensed. Any adjustment of the burrs should be followed by an adjust-
ment of the timer.
1. Remove the two screws from front control panel. Hang the panel under metal hooks at bottom of opening.
2. Enter the Setup Menu “TEST OUTPUTS” - “GRIND MOTOR” (See page 14). Turn grinder motor ON.
3. After all of the coffee in the grind chamber is used, slowly turn the adjusting screw in a clockwise direction
until a metallic whine is heard due to the rubbing of the grinding burrs. (It may be necessary to start more
than one grind cycle to obtain this sound.)
4. Turn plastic grind indicator until screw slot lines up with “O” on the indicator.
5. The following settings approximately correspond to the CBC
recognized grinds.
Turn the adjusting screw counterclockwise to the desired setting
as noted below.
FINE GRIND:
Rotate the adjusting screw 7 hash marks in a
counterclockwise direction.
DRIP GRIND:
Rotate the adjusting screw 8 hash marks in a counterclockwise direction.
REGULAR (COARSE) GRIND:
Rotate the adjusting screw 12 hash marks in a counterclockwise direction.
1 0
2
3
4
5
6
7
8 9 10
11
12
13
14
15
Adjusting
Screw
Hash
Marks