Introduction
The smart battery charger is used to charge SMBUS batteries (Smart Batteries) with
form factors RRC2040, 2040-2, 2054, 2057 or smart batteries with a similar footprint
e.g. 204x range, 205x range, etc..
Caution
Only batteries that comply with the Data Specification 1.0 or 1.1 can be charged with
this battery charger. Other rechargeable batteries or conventional batteries may not
be used.
Tip
Use smart batteries for as long as possible in your device before recharging. The more
completely they are discharged, the more exact the charger can calculate capacity and
charge requirements.
Making Connections
1. Connect the cable from the mains adapter to the battery charger.
2. Connect the power cable to the mains adapter and plug it into the mains socket.
3. The LED is going out after the selftest of the battery charger. The battery charger
is ready for use.
4. If the red control lamp remains on and no battery is in the charger, the battery
charger is defective.
Charging Batteries
1. Connect up the battery charger as described above.
2. Place a discharged Smart Battery into the battery charger.
3. The battery charger makes a battery recognition and intialisation.
4. The battery will be charged. Leave the battery until the green control lamp lights.
5. Then the battery is fully charged. Remove the battery for use.
