Batteries have a life expectancy of greater than 300 cycles with a minimum of 75% of
initial capacity or 1 year per the product warranty.
See section called Supplemental Battery & Charger Instructions for additional battery
information.
Cleaning, Storage, and Disposal
Cleaning – Hood, filter
•
Clean, dry and inspect prior to each use and before storage.
•
Use warm water, mild dishwashing liquid and a soft brush to remove any dirt
from exterior surfaces.
•
Do not immerse equipment in water.
•
Mechanical laundering of loose-fitting hoods is not recommended.
•
Do not soak components in cleaning solutions or solvents.
•
Thoroughly rinse the loose-fitting hood with clean, fresh water and allow to air-
dry.
•
Bullard has tested several common decontamination and cleaning agents to
determine if the integrity of the loose-fitting hood has been compromised after
decontaminating. Based on this testing, it was determined that the hoods did not
suffer any significant degradation when cleaned with these agents after eight
times
o
Coverage Plus NPD (Steris) 1:256 concentration with distilled water
o
Process NPD (Steris) 1:256 concentration with distilled water
o
Spor Klenz (Steris) undiluted
o
Bleach (Clorox) 1% concentration
o
Decon Alcohol (Veltek) 70%
o
Decon Spore (Veltek) 6.4:128 concentration
o
Quant 256 (Buckeye) 1:256 concentration with distilled water
o
Superguard (Buckeye) 1:256 concentration with distilled water
o
Sanicloth HB (Nice-Pak) undiluted
o
SaniWipes (Prochem) undiluted
o
Cavacide (Metrex) undiluted
o
Cidex OPA (Johnson & Johnson) undiluted
Cleaning – Blower motor, breathing tube, shoulder carriage
•
Clean, dry and inspect prior to each use and before storage.
•
Use warm water, mild dishwashing liquid and a soft brush to remove any dirt
from exterior surfaces.
•
As per CDC guidelines for disinfection, diluted household bleach solutions,
alcohol solutions with at least 70% alcohol, and most common EPA-registered
household disinfectants should be effective to disinfect exterior surfaces of the
blower motor, breathing tube, exterior surface of the HEPA filter and shoulder
carriage. Possible disinfection methods include:
o
ECOLAB® KLERCIDE™ 70/30 IPA (EPA Reg. No. 1677-249)
