Bull NovaScale Blade BL265, Инструкция по установке и эксплуатации

Страница: 44 / 92

28
NovaScale Blade BL265 - Installation and User's Guide
DIMM socket Installed
memory
1 2 3 4 5 6 7 8 9 10 11 12
4 DIMMs X X X X
6 DIMMs X X X X X X
8 DIMMs X X X X X X X X
Table 3-5. System memory configuration for mirrored channel mode (2 microprocessors)
To install a DIMM, complete the following steps:
1. Read the safety information that begins on page vii and Installation guidelines on
page 17.
2. Read the documentation that comes with the DIMMs.
3. If the blade server is installed in a Blade Chassis unit, remove it (see Removing the
blade server from the Blade Chassis on page 19 for instructions).
4. Carefully lay the blade server on a flat, static-protective surface.
5. Open the blade server cover (see Removing the blade server cover on page 20 for
instructions).
6. If an expansion unit is installed and you are installing DIMMs on the system board,
remove the expansion unit (see Removing an optional expansion unit on page 21).
7. Locate the DIMM connectors. Determine which DIMM connector you will be installing
memory into.
8. If a DIMM filler or another memory module is already installed in the DIMM connector,
remove it (see Removing a memory module on page 31).
Note A DIMM or DIMM filler must occupy each DIMM socket before the blade
server is turned on.
9. If you are installing a DIMM in DIMM connector seven through twelve, use your fingers
to lift the DIMM access door.