Bull 296/C3, Руководство пользователя, Страница: 54 / 123

Replacing the Service Processor Assembly
To replace the service processor assembly, do the following:
1. Before handling any card, board, or memory DIMM, refer to “Handling Static-Sensitive Devices” on
page 4.
2. Grasp the service processor assembly handles located on top of the new service processor
assembly. Pivot the service processor handles upward to 90 degrees. This action puts the handle
cams into the correct position to help seat the assembly into its connector.
3. Align the service processor assembly with the slot in the system chassis.
4. While holding the service processor assembly by the handles, lower the service processor assembly
into place.
Note: Ensure that the two pins on the top flange of the service processor assembly align with the
corresponding service processor assembly alignment pin holes in the rear bulkhead while you
press the service processor assembly into place.
5. Press firmly on the top of the service processor assembly until you feel it lock into place.
6. Rotate the service processor assembly handles downward until they lock into place.
7. Replace the service access cover as described in “Replacing the 296/C3 Service Access Cover” on
page 12.
8. Reconnect cables to the service processor assembly.
9. Reconnect all system power cables.
10. Return the system to the operating position as described in “Returning the 296/C3 to the Operating
Position” on page 7 or “Placing the 296/E3 into the Service and Operating Position” on page 7.
11. Start the system as described in “Starting the System” on page 8.
38
296/C3 and 296/E3 Parts Guide