Bull 296/C3, Руководство пользователя, Страница: 46 / 123

15. When you are instructed to install the adapter in the adapter slot, carefully grasp the adapter by the
edges and align the adapter in the slot guides. Insert the adapter fully into the adapter slot connector.
If you are installing a full-length adapter, ensure that both ends of the adapter engage the card
guides.
16. Lower the tab onto the PCI adapter faceplate. Rotate the adapter locking latch clockwise until it
covers the tab at approximately a 45-degree angle. See the following illustration.
1
2
3
4
5
1 296/C3 or 296/E3 4 Adapter Retainer Assembly (retainer seat
down and the locking latch in the locked
position)
2 Adapter Retainer Assembly (in the unlocked
position)
5 PCI adapter faceplate (dotted lines)
3 Adapter Retainer Assembly (retainer seat
down and the locking latch in the unlocked
position)
17. If you are installing a short adapter, continue to the next step.
If you are installing a long adapter, do the following:
a. Close and latch the PCI adapter light-pipe plate attached to the fan tray.
b. Note the guide grooves located toward the front of the system in the disk drive backplane, and
align the adapter properly.
18. Connect the adapter cables.
19. On a 296/C3, route the cables through the cable-management arm.
20. Replace the service access cover as described in “Replacing the 296/C3 Service Access Cover” on
page 12 or “Replacing the 296/E3 Service Access Cover” on page 13.
21. Return the system to the operating position as described in “Returning the 296/C3 to the Operating
Position” on page 7 or “Placing the 296/E3 into the Service and Operating Position” on page 7.
22. On a 296/C3, close the rear rack door.
23. Select Install/Configure Devices Added After IPL and press Enter. Follow the instructions on the
screen. Successful replacement is indicated by the
OK
message displayed next to the Command field
at the top of the screen.
30
296/C3 and 296/E3 Parts Guide