Bull Cedoc Bull Escala 2104 DS4, Руководство оператора

Страница: 53 / 117

Chapter 2. Adding disk drive modules
This chapter describes how to add disk drive modules to a 2104 Model DS4 or
Model TS4 that is already installed as part of your system.
You can add disk drive modules only if:
1. You are authorized by your organization.
2. You have the correct disk drive module. Figure 34 shows the disk drive module
for the 2104 Model DS4 or Model TS4. The front of the disk drive module has a
handle
1
that you can pull up to open. Verify the size of the disk drive module
to ensure that you have the correct size and speed. The size and speed of the
disk drive module is shown on the label
2
at the front of the disk drive
module.
Attention:
v Disk drive modules are fragile. Handle them with care. Keep them well away
from strong magnetic fields.
v
Any slot that does not have a disk drive module installed must contain a dummy
disk drive module. The dummy disk drive module ensures that the correct airflow
is maintained around the disk drive modules in the other slots. If a slot remains
empty, overheating might occur.
You do not need to remove power from the 2104 Model DS4 or Model TS4 when
you add a disk drive module.
After you add a disk drive module to a 2104 Model DS4 or Model TS4, you must
add it into your system software configuration by using the system programs. See
“Operating with RISC systems,” on page 69.
1
2
IBM 36.4 GB 10K
U320 S/N AK0B5863
SC000291
Figure 34. Disk drive module handle and label (2104 Model DS4 or Model TS4)
© Copyright IBM Corp. 2003
21